PC Power Supplies Work

The one component that is absolutely vital to the operation of a computer, it is the power supply. Without it, a computer is just a box full of plastic and metal. The power supply converts the alternating current (AC) line from your home to the direct current (DC) needed by the personal computer. 

Power Supply
In a personal computer (PC), the power supply is the metal box usually found in a corner of the case. The power supply is visible from the back of many systems because it contains the power-cord receptacle and the cooling fan.

The small, red switch at right, above the power-cord connector, is for changing line voltages .

Power supplies, often referred to as "switching power supplies", use switcher technology to convert the AC input to lower DC voltages. voltages supplied are 3.3 volts ,5 volts ,12 volts.The 3.3- and 5-volts are typically used by digital circuits, while the 12-volt is used to run motors in diskDrives and fans. The main specification of a power supply is in watts. A watt is the product of the voltage in volts and the current in amperes or amps.

             If you have been around PCs for many years, you probably remember that the original PCs had large red toggle switches that had a good bit of heft to them. When you turned the PC on or off, you knew you were doing it. These switches actually controlled the flow of 120 volt power to the power supply. Today you turn on the power with a little push button, and you turn off the machine with a menu option. These capabilities were added to standard power supplies several years ago. The operating system can send a signal to the power supply to tell it to turn off. The push button sends a 5-volt signal to the power supply to tell it when to turn on. The power supply also has a circuit that supplies 5 volts, called VSB for "standby voltage" even when it is officially "off", so that the button will work.

Switcher Technology
 power supplies tended to be heavy and bulky. They used large, heavy transformers and huge capacitors to convert line voltage at 120 volts and 60 hertz into 5 volts and 12 volts DC.

The switching power supplies used today are much smaller and lighter. They convert the 60-Hertz (Hz, or cycles per second) current to a much higher frequency, meaning more cycles per second. This conversion enables a small, lightweight transformer in the power supply to do the actual voltage step-down from 110 volts (or 220 in certain countries) to the voltage needed by the particular computer component. The higher-frequency AC current provided by a switcher supply is also easier to rectify and filter compared to the original 60-Hz AC line voltage, reducing the variances in voltage for the sensitive electronic components in the computer.

To the left are two cylindrical capacitors. The large finned pieces of aluminum are heat sinks. The left heat sink has transistors attached to it. These are the transistors in charge of doing the switching -- they provide high-frequency power to the transformers.

A switcher power supply draws only the power it needs from the AC line. The typical voltages and current provided by a power supply are shown on the label on a power supply.

Personal computer power supply label. VSB is the standby voltage provided to the power switch.

Switcher technology is also used to make AC from DC, as found in many of the automobile power inverters used to run AC appliances in an automobile and in uninterruptible power supplies. Switcher technology in automotive power inverters changes the direct current from the auto battery into alternating current. The transformer uses alternating current to make the transformer in the inverter step the voltage up to that of household appliances .

Power Supply Standardization
Over time, there have been at least six different standard power supplies for personal computers. Recently, the industry has settled on using ATX-based power supplies. ATX is an industry specification that means the power supply has the physical characteristics to fit a standard ATX case and the electrical characteristics to work with an ATX motherboard.

PC power-supply cables use standardized, keyed connectors that make it difficult to connect the wrong ones. Also, fan manufacturers often use the same connectors as the power cables for disk drives, allowing a fan to easily obtain the 12 volts it needs. Color-coded wires and industry standard connectors make it possible for the consumer to have many choices for a replacement power supply.

A PC power supply removed from its PC case. Cables and connectors at right supply DC voltages.

Advanced Power Management
This offers a set of five different states that your system can be in. It was developed by Microsoft and Intel for PC users who wish to conserve power. Each system component, including the operating system, basic input/output system (BIOS), motherboard and attached devices all need to be APM-compliant to be able to use this feature. Should you wish to disable APM because you suspect it is using up system resources or causing a conflict, the best way to do this is in the BIOS. That way, the operating system won't try to reinstall it, which could happen if it were disabled only in the software.

Power Supply Problems
The PC power supply is probably the most failure-prone item in a personal computer. It heats and cools each time it is used and receives the first in-rush of AC current when the PC is switched on. Typically, a stalled cooling fan is a predictor of a power supply failure due to subsequent overheated components. All devices in a PC receive their DC power via the power supply. A typical failure of a PC power supply is often noticed as a burning smell just before the computer shuts down. Another problem could be the failure of the vital cooling fan, which allows components in the power supply to overheat. Failure symptoms include random rebooting or failure in Windows for no apparent reason.

If any problems you suspect to be the fault of the power supply, the documentation that came with your computer can be use. If you have ever removed the case from your personal computer to add an adapter card or memory, you can change a power supply. Make sure you remove the power cord first, since voltages are present even though your computer is off.